Tags: Character Analysis Essay FormatBusiness Plan Template OutlineHelp With Writing Psychology EssaysMit Sloan Essay Questions 2014Term Paper Introduction ExampleExample Of Market Research ProposalCompare Contrast Essay Words UseSolving Square Root ProblemsSmu AssignmentScience Papers Gcse Ed
Once logged into your router click on the "NAT/Qo S" tab. This week I configured a network with two routers and multiple subnets using DD-WRT. This following graphics represent the physical topology of the network. First step is to replace the stock firmware by a DD-WRT firmware.
I did a little bit of Googling & some experimenting and ended up with a solution I was happy with.I called them up & had the service installed & activated.The installation consisted of a special, proprietary, AT&T VDSL modem, a DC Power Supply, & a special, AT&T 2Wire Router model i38HG.To my initial dismay, I found that the VDSL modem could not function without the AT&T 2Wire Router.This was a problem for me as the 2Wire Router is limited in functionality and I was used to administering my home network using a Linksys WRT54G with DD-WRT firmware installed.I have also upgraded my router from the WRT54G to a TP-Link TL-WDR3600 with DD-WRT firmware.Not surprisingly the DD-WRT interface is the same on both units.The trick to getting everything to work is ensuring that the settings are correct on both the i38HG/5268AC & WRT54G/TL-WDR3600 (running DD-WRT).Below is a explanation of the steps to go through to set your network up like mine.The 5268AC uses a "Device Access Code" instead which is printed on the bottom of the unit.Some routers & modems work best with port forwarding if you have a static local IP.